Drywallers put the finishing touches on our home and office interiors by installing and finishing sheetrock walls. Physical stamina is required to lift, cut, and maneuver heavy sheets of drywall and fix them in place. Finishing and sanding seams is also an ergonomic and physical challenge. Consider that this demanding work is often done on a construction site and at heights, and it is clear that drywallers need to think safety on the job.
Lifting and maneuvering tools and heavy, awkward sheets of drywall pose an ergonomic risk for drywallers. Maintaining good physical condition and using proper lifting techniques can reduce the chance of injury and strain. Working in pairs makes it easier to lift, position, and control sheetrock. Seam taping and sanding tools with spring-assisted or powered systems make overhead finishing work easier by reducing the force that workers must apply. Completing work one task at a time (hanging, taping, finishing, etc.) may be efficient, but is harder on the body; completing one area at a time allows workers to rotate tasks and give muscles a break.
Because drywallers work at heights to install tall walls and ceilings, they need to use extra caution to prevent falls. Workers can use ladders if the work can be done safely from them, but they should follow ladder safety rules. Lean-to or jack scaffolds, shore scaffolds, nailed brackets, loose tile, loose brick, loose blocks, and other unstable objects cannot be used as working platforms or for their supports. Stilts should never be used due to their instability. Sturdy scaffolds or steps that are at least 20 inches wide provide safe, stable working platforms when installed and used correctly.
Dust is a hazard for drywallers at the beginning and end of every job. When sheetrock is cut, the gypsum dust that is released can be irritating to the eyes and lungs. Dust from dry mixing joint compound can be an irritant; pre-mixed compounds can reduce worker dust exposure. Sanding finished joints can also create a lot of dust. Whenever job tasks may create dust, safety glasses and respirators or dust masks should be used to protect workers’ eyes and lungs. Proper ventilation on the jobsite can reduce dust in the air.
Electrical safety should be considered when drywallers are fastening sheetrock to wall frames. Workers should use caution around interior wall wiring and ensure that electric boxes have proper shielding to prevent screws and nails from penetrating them. Powered nail guns, fasteners, and drills should be properly grounded and in good working order to reduce the risk of electric shock. Other tools, especially cutting tools, should be in good working order and used properly.
Because drywalling is usually one of the last tasks on a construction job, it is often done under deadline pressure. However, the need for speed is never an excuse to forget safety. Good planning and safety procedures give a drywalling job a smooth finish.
The above evaluations and/or recommendations are for general guidance only and should not be relied upon for legal compliance purposes. They are based solely on the information provided to us and relate only to those conditions specifically discussed. We do not make any warranty, expressed or implied, that your workplace is safe or healthful or that it complies with all laws, regulations or standards. Article https://goo.gl/Xlfdno Photo https://goo.gl/Xlfdno